Barebow - lower three finger shooting

The lower three-finger shooting method is common in light bows. This shooting method is convenient for aiming with eyes. For example, APCC light bow champion Chen Chen uses the lower three-finger shooting method.
From the above picture, we can see that after the bow is opened, the tail of the arrow and the bowstring are at an oblique angle, not relatively close. In this way, when releasing, the force exerted by the bowstring on the arrow is not vertical, which may cause the arrow to be inserted from bottom to top after it is inserted into the target.

If the lower three-finger shooting method is used, the above situation is probabilistic. So as a competition, all details must be very rigorous. We must avoid this possibility. Combined with the method given by someone in a certain bar before, the following method is given:
The reserved position of the bayonet is based on the T card 10 scale. Normally, 2 grids can be reserved. Then the lower three fingers need to be reserved to 3 grids, because the tail of the arrow has an oblique range of activity from before the bow is opened to after the bow is opened. It cannot be reserved too much, otherwise the target will be high or low.

Bowstring positioning material
The positioning material cannot use copper buckles, why? Because the copper buckle is too hard, the arrow tail has a slope when shooting, which will cause the arrow to be squeezed out along the slope when the bow is opened, resulting in empty release.

Arrow tail improvement or purchase
It is very difficult for most people to grind the arrow tail mouth by themselves, and it is difficult to ensure the consistency of the arrow after manual grinding. Then you can buy the oblique arrow tail on the market, such as the Bet arrow tail, which can not only correct the angle of force tilt, but also make the force area of ​​the arrow tail larger, and the arrow will be more stable!